The ModuLite® works on all vehicle types including standard, PWM and/or multiplex systems. The ModuLite® is rated at 42 amps for turn/stop circuits and 75 amps for taillight circuits. The included current sensors snap on to provide easy installation. The Tekonsha ZCI™ Zero Contact Interface Universal ModuLite® & Installation Kit activates a trailer’s stop/turn/tail/running lights without cutting or splicing into your vehicles wiring system. The Tekonsha ZCI™ Zero Contact Interface Universal ModuLite® & Installation Kit uses a special magnet to connect the How does the Tekonsha ZCI™ Zero Contact Interface Universal ModuLite® & Installation Kit work?.Third, it’s completely invisible once installed, so it won’t detract from the look of your vehicle. Second, it doesn’t require any special tools or knowledge to install. First, it’s much easier to install than a traditional brake controller. There are a few advantages to using the Tekonsha ZCI™ Zero Contact Interface Universal ModuLite® & Installation Kit. Why would I want to use the Tekonsha ZCI™ Zero Contact Interface Universal ModuLite® & Installation Kit?.The kit comes with everything you need to install the brake controller, including the necessary wiring and connectors. The Tekonsha ZCI™ Zero Contact Interface Universal ModuLite® & Installation Kit is a special device that allows you to install a trailer’s brake controller without having to wire it directly into the vehicle’s electrical system. What is the Tekonsha ZCI™ Zero Contact Interface Universal ModuLite® & Installation Kit?.Common Questions on Tekonsha ZCI™ Zero Contact Interface Universal ModuLite® & Installation Kit The ModuLite is also equipped with short circuit/overload protection, and is rated at 42 amps for turn/stop circuits and 75 amps for taillight circuits. This ensures that your trailer lights will operate independently of your vehicle’s electrical system, and that there will be no interference with the tow vehicle’s electrical system. The kit comes with current sensors that snap onto your trailer’s light assemblies, and the module connects directly to your vehicle’s battery. The Tekonsha ZCI™ Zero Contact Interface Universal ModuLite® & Installation Kit is a great way to activate your trailer’s stop/turn/tail/running lights without having to cut or splice into your vehicle’s wiring system. That’s it! Your ZCI Zero Contact Modulite is now installed and ready to be used. Thread the included screws through each of the grommets and hand-tighten them so that they’re snug but not overly tight.Ħ. Place one of these over each of the exposed metal contact points on the back of the module.ĥ. Now take the installation kit and locate the two rubber grommets. You may need to use a small amount of force to get it properly seated.Ĥ. Once you’re happy with the positioning, gently push the module into place so that the metal contacts make contact with the holes. Take out the module and hold it against the inside of your headlight housing, making sure that the two metal contact points are lined up with the corresponding holes in the housing.ģ. You should find the module itself, along with an instruction manual and installation kit.Ģ. Here’s a step-by-step guide on how to do it:ġ.Firstly, open up the package and remove the contents. If you’re looking for a safe, easy and quick way to install your ZCI Zero Contact Modulite and Installation Kit, then you’ve come to the right place.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |